Effect of Winglets on Improving Wind Turbine Performance

Sri Utami Handayani

doi:10.14710/jvsar.v3i1.10906

DOI: https://doi.org/10.14710/jvsar.v3i1.10906

Effect of Winglets on Improving Wind Turbine Performance

*Sri Utami Handayani

- Department of Industrial Technology, Vocational School, Diponegoro University, Indonesia

Citation Format:

Abstract

Indonesia, with the longest coastline in the world, has enormous potential to develop large-scale wind energy. In wind turbines, the formation of a wake behind the wind turbine can reduce efficiency. It is estimated that the formation of a vortex tip behind the wind turbine blade can be reduced by adding a winglet. The main function of winglets attached to the blade is to reduce the effect of the wingtip vortices which are generated due to 3D spanwise flow that occurs because of the pressure non- equalization between the upper and lower blade surfaces. This paper aims to summarize the results of research on the effect of adding winglets to wind turbines.

Fulltext View|Download

Keywords: wind turbine, winglet, tip vortices, alternative energy, wake

Article Metrics:

Article Info

Section: Articles

Language : EN

In Volume 3, Issue 1, Year 2021 (April 2021)

Recent articles

Effect of Winglets on Improving Wind Turbine Performance Mechanical Properties of Commercial Recycled Polypropylene from Plastic Waste Impact of Fintech on Student Lifestyle In Pekalongan City, Indonesia More recent articles

Tim Sekretaris Jenderal Dewan Energi Nasional, “Indonesia Energy Out Look 2019,” J. Chem. Inf. Model., vol. 53, no. 9, pp. 1689–1699, 2019
C. L. Zhang, Z. H. Lai, M. Q. Li, and D. Yurchenko, “Wind energy harvesting from a conventional turbine structure with an embedded vibro-impact dielectric elastomer generator,” J. Sound Vib., vol. 487, 2020
E. Martínez-Mendoza, L. A. Rivas-Tovar, E. Fernández-Echeverría, and G. Fernández-Lambert, “Social impact of wind energy in the Isthmus of Tehuantepec, Mexico, using Likert-fuzzy,” Energy Strateg. Rev., vol. 32, no. September 2019, 2020
Kusch-Brandt, Renewables 2019 Global Status Report, vol. 8, no. 3. 2019
H. P Dida, S. Suparman, and D. Widhiyanuriyawan, “Pemetaan Potensi Energi Angin di Perairan Indonesia Berdasarkan Data Satelit QuikScat dan WindSat,” J. Rekayasa Mesin, vol. 7, no. 2, pp. 95–101, 2016
S. U. Handayani, “Karakterisasi Daya dan Pola Alira Turbin Angin Kecepatan Rendah dengan Winglet,” Program Pasca Sarjana Universitas Gadjah Mada, 2007
D. H. Wood, “Maximum wind turbine performance at low tip speed ratio,” J. Renew. Sustain. Energy, vol. 7, no. 5, 2015
S. Sunada, K. Ozaki, M. Tanaka, T. Yasuda, K. Yasuda, and K. Kawachi, “Airfoil characteristics at a low Reynolds number,” J. Flow Vis. Image Process., vol. 7, no. 3, pp. 207–215, 2000
R. Kumar and P. Baredar, “Solidity Study and its Effects on the Performance of A Small Scale Horizontal Axis Wind Turbine,” Impending Power Demand Innov. Energy Paths, vol. 84, no. 8, pp. 290–297, 2015
M. M. Duquette and K. D. Visser, “Numerical implications of solidity and blade number on rotor performance of horizontal-axis wind turbines,” J. Sol. Energy Eng. Trans. ASME, vol. 125, no. 4, pp. 425–432, 2003
S. U. Handayani, “Penambahan Winglet untuk Meningkatkan Unjuk Kerja Turbin Angin pada Kecepatan Angin Rendah.pdf,” in Prosiding Seminar Nasional SNTTM, Universitas Syiah Kuala Banda Aceh, 2007
T. Reports, “Experimental Studies of Wind Turbine Wakes Power Optimisation and Meandering Davide Medici,” no. December, 2005
S. Nima, “The effect of unsteady flow on wind turbine wake development and noise generation Nima Sedaghatizadeh,” 2017
S. U. Handayani, “Velocity Distribution of Low Velocity Wind Turbine with Winglet,” J. Tek. Gelagar, vol. 19, no. 02, 2008
J. Johansen and N. N. Sorensen, “Numerical Analysis of Winglets on Wind Turbine Blades using CFD Numerical Analysis of Winglets on Wind Turbine Blades using CFD,” no. April, pp. 2–8, 2014
M. Khaled, M. M. Ibrahim, H. E. Abdel Hamed, and A. F. AbdelGwad, “Investigation of a small Horizontal–Axis wind turbine performance with and without winglet,” Energy, vol. 187, p. 115921, 2019
C. Papadopoulos, M. Schmid, P. Kaparos, D. Misirlis, and Z. Vlahostergios, “Numerical analysis and optimization of a winglet for a small horizontal wind turbine blade,” Chem. Eng. Trans., vol. 81, pp. 1321–1326, 2020

Last update:

No citation recorded.

Last update:

No citation recorded.

Journal of Vocational Studies on Applied Research are published under the terms of the Creative Commons Attribution-ShareAlike. Authors retain the copyright to their work. Users may read, copy and distribute the work in any medium provided the authors and the journal are appropriately credited.

Below you may find the full text of the license signed by authors.

LICENSE TO PUBLISH

1. License
The non-commercial use of the article will be governed by the Creative Commons Attribution-ShareAlike license as currently displayed on http://creativecommons.org/licenses/by-sa/4.0/. Without prejudice to the foregoing, the author hereby grants Journal of Vocational Studies on Applied Research the exclusive license for commercial use of the article according to section 2 below, and sections 4 through 9 below, throughout the world, in any form, in any language, for the full term of copyright, effective upon acceptance for publication.

2. Author’s Warranties
The author warrants that the article is original, written by stated author/s, has not been published before, contains no unlawful statements, does not infringe the rights of others, is subject to copyright that is vested exclusively in the author and free of any third party rights, and that any necessary written permissions to quote from other sources have been obtained by the author/s.

3. User Rights
Under the Creative Commons Attribution-ShareAlike license, the author(s) and users are free to share (copy, distribute and transmit the contribution).

4. Rights of Authors
Authors retain the following rights:

copyright, and other proprietary rights relating to the article, such as patent rights,
the right to use the substance of the article in future own works, including lectures and books,
the right to reproduce the article for own purposes, provided the copies are not offered for sale,
the right to self-archive the article.

5. Co-Authorship
If the article was prepared jointly with other authors, the signatory of this form warrants that he/she has been authorized by all co-authors to sign this agreement on their behalf, and agrees to inform his/her co-authors of the terms of this agreement.

6. Termination
This agreement can be terminated by the author or Journal of Vocational Studies on Applied Research upon two months’ notice where the other party has materially breached this agreement and failed to remedy such breach within a month of being given the terminating party’s notice requesting such breach to be remedied. No breach or violation of this agreement will cause this agreement or any license granted in it to terminate automatically or affect the definition of Journal of Vocational Studies on Applied Research.

7. Royalties
This agreement entitles the author to no royalties or other fees. To such extent as legally permissible, the author waives his or her right to collect royalties relative to the article in respect of any use of the article by Journal of Vocational Studies on Applied Research or its sublicensee.

8. Miscellaneous
Journal of Vocational Studies on Applied Research will publish the article (or have it published) in the Journal, if the article’s editorial process is successfully completed and Journal of Vocational Studies on Applied Research or its sublicensee has become obligated to have the article published. Journal of Vocational Studies on Applied Research may conform the article to a style of punctuation, spelling, capitalization and usage that it deems appropriate. The author acknowledges that the article may be published so that it will be publicly accessible and such access will be free of charge for the readers. Journal of Vocational Studies on Applied Research will be allowed to sublicense the rights that are licensed to it under this agreement.