Optimization and Characterization of Physical–Mechanical Properties of Biodegradable Edible Films Based on Pectin from Breadfruit Peel for Food Packaging

Andi Hidayatullah Mappamadeng; Rizka Amalia

doi:10.14710/jvsar.v4i1.14175

DOI: https://doi.org/10.14710/jvsar.v4i1.14175

Optimization and Characterization of Physical–Mechanical Properties of Biodegradable Edible Films Based on Pectin from Breadfruit Peel for Food Packaging

*Andi Hidayatullah Mappamadeng - Industrial Chemical Engineering, Vocational School, Diponegoro University, Indonesia

Rizka Amalia

- Industrial Chemical Engineering, Vocational School, Diponegoro University, Indonesia

BibTex Citation Data :

@article{JVSAR14175,
    author = {Andi Mappamadeng and Rizka Amalia},
    title = {Optimization and Characterization of Physical–Mechanical Properties of Biodegradable Edible Films Based on Pectin from Breadfruit Peel for Food Packaging},
    journal = {Journal of Vocational Studies on Applied Research},
  volume = {4},
    number = {1},
    year = {2022},
    keywords = {Bioedible film; Breadfruit peel;Pectin; Food packaging},
    abstract = {   Abstract -      This study aims to determine the   characteristics   and   optimization   of   biodegradable   film  s based on pectin from   breadfruit peel.   The study was employed using a factorial design   with   multiple   variables: pectin (2 and 4 grams), sorbitol concentration (10% and 20%) and drying temperature (120 0 C and 140 0 C) were studied. The results   obtained from eight samples   show  ed   that the water vapor transmission rate   was   in the range of 3.525 - 6.952 g/m 2 .day. The best  -achieved   water vapor transmission rate (3,525 g/m 2 .day) was obtained at   specific   operating conditions  , namely 4 grams of pectin  , 20%   of   sorbitol concentration and drying temperature of 140 0 C. In this   study  , the most influential   factor for   water vapor transmission rate is   pectin weight   with the value effect of -1.238. The   highest   tensile strength test and   percentage   elongation were 116.55 kgf/cm 2  and 10%, respectively. The FTIR analysis   showed   that the   pectin from   breadfruit peel   was according to   commercial pectin standard,   by   the presence of OH and ester (COOH) groups.   The SEM Analysis showed    that the molecular structure of   edible films   did not look porous, dense, but not   flat   on its surface  , thus   less permeable to air  .    Keywords    -   Bioedible film, Breadfruit peel, Pectin, Food packaging },
   issn = {2684-8090},   pages = {1--6}  doi = {10.14710/jvsar.v4i1.14175},
    url = {https://ejournal2.undip.ac.id/index.php/jvsar/article/view/14175}
}

Citation Format:

Abstract

Abstract - This study aims to determine the characteristics and optimization of biodegradable films based on pectin from breadfruit peel. The study was employed using a factorial design with multiple variables: pectin (2 and 4 grams), sorbitol concentration (10% and 20%) and drying temperature (120⁰C and 140⁰C) were studied. The results obtained from eight samples showed that the water vapor transmission rate was in the range of 3.525 - 6.952 g/m².day. The best-achieved water vapor transmission rate (3,525 g/m².day) was obtained at specific operating conditions, namely 4 grams of pectin, 20% of sorbitol concentration and drying temperature of 140⁰C. In this study, the most influential factor for water vapor transmission rate is pectin weight with the value effect of -1.238. The highest tensile strength test and percentage elongation were 116.55 kgf/cm² and 10%, respectively. The FTIR analysis showed that the pectin from breadfruit peel was according to commercial pectin standard, by the presence of OH and ester (COOH) groups. The SEM Analysis showed that the molecular structure of edible films did not look porous, dense, but not flat on its surface, thus less permeable to air.

Keywords - Bioedible film, Breadfruit peel, Pectin, Food packaging

Fulltext View|Download

Keywords: Bioedible film; Breadfruit peel;Pectin; Food packaging

Article Metrics:

Article Info

Section: Articles

Language : EN

In Volume 4, Issue 1, Year 2022 (April 2022)

Recent articles

Optimization of Manufacturing liquid Soap Based on Virgin Coconut Oil with a Combination Potassium Hydroxide and Ammonium Hydroxide Optimization and Characterization of Physical–Mechanical Properties of Biodegradable Edible Films Based on Pectin from Breadfruit Peel for Food Packaging Optimization of Pb(II) Metal Adsorption on Pomelo Peel Biosorbent by Immobilization in Ca-Alginate More recent articles

Kementerian Lingkungan Hidup dan Kehutanan RI, Statistik Lingkungan Hidup Indonesia: Rekalkulasi Penutupan Lahan Indonesia Tahun 2019. 2020
S. Widyaningsih, D. Kartika, and Y. T. Nurhayati, “Pengaruh penambahan sorbitol dan kalsium karbonat terhadap karakteristik dan sifat biodegradasi film dari pati kulit pisang,” Molekul, vol. 7, no. 1, pp. 69–81, 2012
O. Fennema, I. G. Donhowe, and J. J. Kester, “Lipid type and location of the relative humidity gradient influence on the barrier properties of lipids to water vapor,” in Water in Foods, Elsevier, 1994, pp. 225–239
Badan Pusat Statistika, Statistik Tanaman Buah Buahan dan Sayur Sayuran Indonesia. 2017
B. H. Madjaga, N. Nurhaeni, and R. Ruslan, “Optimalisasi ekstraksi pektin dari kulit buah sukun (Artocarpus Altilis),” KOVALEN J. Ris. Kim., vol. 3, no. 2, pp. 158–165, 2017
A. Gennadios, Protein-based films and coatings. CRC press, 2002
A. W. Astuti, “Pembuatan Edible Film Dari Semirefine Carrageenan (Kajian Konsentrasi Tepung Src Dan Sorbitol).” Tesis. Jawa Timur: UPN, 2010
I. Zuwanna and H. Meilina, “Pengemas Makanan Ramah Lingkungan, Berbasis Limbah Cair Tahu (Whey) Sebagai Edible Film,” 2017
S. Bolton, “Pharmaceutical Statistic Practical and Clinical Application,” vol. 3, pp. 595–596, 1997, doi: 10.1016/S0006-4971(20)69354-5
T. H. McHUGH, J. Aujard, and J. M. Krochta, “Plasticized whey protein edible films: water vapor permeability properties,” J. Food Sci., vol. 59, no. 2, pp. 416–419, 1994
Z. Liu and J. H. Han, “Film‐forming characteristics of starches,” J. Food Sci., vol. 70, no. 1, pp. E31–E36, 2005
A. D. Putra, V. S. Johan, and R. Efendi, “Penambahan sorbitol sebagai plasticizer dalam pembuatan edible film pati sukun.” Riau University, 2017
A. Salsabila, W. T. Revilia, M. H. Anwar, and B. Education, “Characteristics of Thickness and Permeability of Water Vapour on Edible Film Made From Banana Peels Kepok Pectin With the Addition of Sorbitol. 4.” Icons, 2017
R. Yulianti and E. Ginting, “Perbedaan karakteristik fisik edible film dari umbi-umbian yang dibuat dengan penambahan plasticizer,” 2012
A. Syarifuddin and Y. Yunianta, “Karakterisasi edible film dari pektin albedo jeruk bali dan pati garut [in press september 2015],” J. Pangan dan Agroindustri, vol. 3, no. 4, 2015
M. Petersson and M. Stading, “Water vapour permeability and mechanical properties of mixed starch-monoglyceride films and effect of film forming conditions,” Food Hydrocoll., vol. 19, no. 1, pp. 123–132, 2005
W. Warkoyo, B. Rahardjo, D. W. Marseno, and J. N. W. Karyadi, “Sifat fisik, mekanik dan barrier edible film berbasis pati umbi kimpul (Xanthosoma sagittifolium) yang diinkorporasi dengan kalium sorbat,” Agritech, vol. 34, no. 1, pp. 72–81, 2014
T. Bourtoom, “Edible films and coatings: characteristics and properties,” Int. food Res. J., vol. 15, no. 3, pp. 237–248, 2008
S. Harumarani and W. F. Ma’ruf, “Pengaruh Perbedaan Konsentrasi Gliserol Pada Karakteristik Edible film Komposit Semirefined Karagenan Eucheuma Cottoni Dan
I. Khotimah and S. Tjahjani, “Peningkatan Sifat Mekanik
Edible Film Dari Bungkil Kedelai Menggunakan Kitosan
Sorbitol Sebagai Pengemas Produk Pangan,” UNESA J. Chem.,
vol. 9, no. 2, pp. 144–150, 2020
Beeswax,” J. Pengolah. Dan Bioteknol. Has. Perikan., vol. 5, no. 1, pp. 101–105, 2016
Spectral Database for Organic Compounds (SDBS), 2019, IR KBr Disc Pectin (from Citrus) SDBS No. 2656, https:// sdbs. db. aist.go-jp/sdbd/cgi-bin/ direct_frame_ top.cgi,
N. S. M. Ismail, N. Ramli, N. M. Hani, and Z. Meon, “Extraction and characterization of pectin from dragon fruit (Hylocereus polyrhizus) using various extraction conditions,” Sains Malaysiana, vol. 41, no. 1, pp. 41–45, 2012
W. Ban, J. Song, D. S. Argyropoulos, and L. A. Lucia, “Improving
the physical and chemical functionality of starch‐derived f
ilms with biopolymers,” J. Appl. Polym. Sci., vol. 100, no. 3, pp
–2548, 2006

Last update:

No citation recorded.

Last update:

No citation recorded.

Journal of Vocational Studies on Applied Research are published under the terms of the Creative Commons Attribution-ShareAlike. Authors retain the copyright to their work. Users may read, copy and distribute the work in any medium provided the authors and the journal are appropriately credited.

Below you may find the full text of the license signed by authors.

LICENSE TO PUBLISH

1. License
The non-commercial use of the article will be governed by the Creative Commons Attribution-ShareAlike license as currently displayed on http://creativecommons.org/licenses/by-sa/4.0/. Without prejudice to the foregoing, the author hereby grants Journal of Vocational Studies on Applied Research the exclusive license for commercial use of the article according to section 2 below, and sections 4 through 9 below, throughout the world, in any form, in any language, for the full term of copyright, effective upon acceptance for publication.

2. Author’s Warranties
The author warrants that the article is original, written by stated author/s, has not been published before, contains no unlawful statements, does not infringe the rights of others, is subject to copyright that is vested exclusively in the author and free of any third party rights, and that any necessary written permissions to quote from other sources have been obtained by the author/s.

3. User Rights
Under the Creative Commons Attribution-ShareAlike license, the author(s) and users are free to share (copy, distribute and transmit the contribution).

4. Rights of Authors
Authors retain the following rights:

copyright, and other proprietary rights relating to the article, such as patent rights,
the right to use the substance of the article in future own works, including lectures and books,
the right to reproduce the article for own purposes, provided the copies are not offered for sale,
the right to self-archive the article.

5. Co-Authorship
If the article was prepared jointly with other authors, the signatory of this form warrants that he/she has been authorized by all co-authors to sign this agreement on their behalf, and agrees to inform his/her co-authors of the terms of this agreement.

6. Termination
This agreement can be terminated by the author or Journal of Vocational Studies on Applied Research upon two months’ notice where the other party has materially breached this agreement and failed to remedy such breach within a month of being given the terminating party’s notice requesting such breach to be remedied. No breach or violation of this agreement will cause this agreement or any license granted in it to terminate automatically or affect the definition of Journal of Vocational Studies on Applied Research.

7. Royalties
This agreement entitles the author to no royalties or other fees. To such extent as legally permissible, the author waives his or her right to collect royalties relative to the article in respect of any use of the article by Journal of Vocational Studies on Applied Research or its sublicensee.

8. Miscellaneous
Journal of Vocational Studies on Applied Research will publish the article (or have it published) in the Journal, if the article’s editorial process is successfully completed and Journal of Vocational Studies on Applied Research or its sublicensee has become obligated to have the article published. Journal of Vocational Studies on Applied Research may conform the article to a style of punctuation, spelling, capitalization and usage that it deems appropriate. The author acknowledges that the article may be published so that it will be publicly accessible and such access will be free of charge for the readers. Journal of Vocational Studies on Applied Research will be allowed to sublicense the rights that are licensed to it under this agreement.