skip to main content

Pengaruh Penyemprotan Larutan Asam Hipoklorit (HOCl) dengan Konsentrasi dan Durasi Berbeda terhadap Stabilitas Dimensi Hasil Cetakan Alginat

The Effect of Hypochlorous Acid (HOCl) Solution with Different Concentrations and Durations on the Dimensional Stability of Alginate Impressions

1Department of Dentistry, Universitas Diponegoro, Indonesia

2Faculty of Medicine, Universitas Diponegoro, Indonesia

3Department of Dentistry, Faculty of Medicine, Universitas Diponegoro, Indonesia

Received: 14 Feb 2025; Revised: 13 Mar 2025; Accepted: 13 Mar 2025; Available online: 14 Mar 2025; Published: 1 Jun 2025.
Open Access Copyright 2025 Johanna Kezia Prajogo, Faizah Fulyani, Brigitta Natania Renata Purnomo, Oedijani Santoso
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

Citation Format:
Abstract

Background: Disinfection of alginate impressions is performed to prevent cross-infection. Alginate possesses properties of imbibition and syneresis which affect the dimensional stability of the impression. The disinfectant solution, hypochlorous acid (HOCl), is non-toxic, non-irritating, and non-corrosive at the appropriate concentrations. Hypochlorous acid has higher antimicrobial activity than sodium hypochlorite (NaOCl). Objective: This study aimed to determine the effect of spraying 0.01% and 0.02% HOCl with contact durations of 1 and 5 minutes on the dimensional stability of alginate impressions. Methods: This was a laboratory experimental study with a Post-Test Only Control Group Design. A total of 24 samples were divided into 4 treatment groups and 2 control groups. The dimensional stability of the alginate impressions was assessed by the difference in anteroposterior and mediolateral dimension measurements between the master model and the resulting gypsum casts, using a digital caliper. Measurements were taken 3 times by 3 different observers, followed by a two-way ANOVA statistical test. Results: The results of the two-way ANOVA test showed no significant difference between the groups with variations in concentration or contact duration. The largest dimensional difference was found in the control group sprayed with 5.25% NaOCl. Conclusion: Spraying alginate impressions with 0.01% and 0.02% HOCl with contact durations of 1 and 5 minutes does not affect the dimensional stability of the alginate impressions.

Fulltext View|Download
Funding: Universitas Diponegoro

Article Metrics:

  1. Sakaguchi RL, Powers JM. Craig’s Restorative Dental Materials. 14th ed. St. Louis, Missouri: Elsevier Health Sciences; 2018. 229–268 p
  2. Ulgey M, Gorler O, Yesilyurt G. Importance of disinfection time and procedure with different alginate impression products to reduce dimensional instability. Niger J Clin Pract. 2020;23(3):284
  3. Vrbova R, Bradna P, Bartos M, Roubickova A. The effect of disinfectants on the accuracy, quality and surface structure of impression materials and gypsum casts: A comparative study using light microscopy, scanning electron microscopy and micro computed tomography. Dent Mater J. 2020;39(3):500–8
  4. Pakdin M, Soufiabadi S, Shahrakipour M. Evaluation of Contamination Reduction on Gypsum Casts from Alginate Impressions Disinfected with Four Different Materials. Glob J Health Sci. 2016;8(12):127
  5. Bustos J, Herrera R, González U, Martínez A, Catalán A, González U. Effect of inmersion desinfection with 0.5% sodium hypochlorite and 2% glutaraldehyde on alginate and silicone: Microbiology and SEM study. Int J Odontostomat. 2010;4(2):169–77
  6. Borgo LF, Bozzetti FDA, Flor JF, Mello PS de, Kaiser TDL. Evaluation of bacterial contamination on irreversible hydrocolloid impressions before and after disinfection. Rev Bras Odontol. 2018;75:1
  7. Nagamatsu Y, Chen K-K, Nagamatsu H, Kozono Y, Shimizu H. Application of neutral electrolyzed water to disinfection of alginate impression. Dent Mater J. 2016;35(2):270–7
  8. Ismail HA, Mahross HZ, Shikho S. Evaluation of dimensional accuracy for different complete edentulous impressions immersed in different disinfectant solutions. Eur J Dent. 2017;11(02):242–9
  9. Raval HJ, Mahajan N, Sethuraman R, Y. NG. Comparative evaluation of anticandidal activity of pre-incorporated quaternary ammonium compound disinfectant alginate with 5.25% sodium hypochlorite spray disinfectant on the conventional alginate: An In Vivo study. J Pierre Fauchard Acad (India Sect). 2017;31(2–4):99–104
  10. AlZain S. Effect of chemical, microwave irradiation, steam autoclave, ultraviolet light radiation, ozone and electrolyzed oxidizing water disinfection on properties of impression materials: A systematic review and meta-analysis study. Saudi Dent J. 2020;32(4):161–70
  11. Trivedi R, Sangur R, Bathala LR, Srivastava S, Madhav S, Chaubey P. Evaluation of efficacy of Aloe Vera as a Disinfectant by Immersion and Spray methods on Irreversible Hydrocolloid Impression Material and its Effect on the Dimensional Stability of Resultant Gypsum Cast - An in Vitro Study. J Med Life. 2019;12(4):395–402
  12. Eryilmaz M, Palabiyik I. Hypochlorous Acid - Analytical Methods and Antimicrobial Activity. Trop J Pharm Res. 2013;12(1)
  13. Ishihara M, Murakami K, Fukuda K, Nakamura S, Kuwabara M, Hattori H, et al. Stability of Weakly Acidic Hypochlorous Acid Solution with Microbicidal Activity. Biocontrol Sci. 2017;22(4):223–7
  14. Babiker GH, Nadia Khalifa BDS, Nasser M, Alhajj BDS. Dimensional accuracy of alginate impressions using different methods of disinfection with varying concentrations. Compendium. 2018;39(1)
  15. Block MS, Rowan BG. Hypochlorous Acid: A Review. J Oral Maxillofac Surg. 2020;78(9):1461–6
  16. Council adopts American Dental Association Specification No. 18 (Alginate Impression Material). J Am Dent Assoc. 1968;77(6):1354–8
  17. Al Shikh A, Milosevic A. Effectiveness of Alcohol and Aldehyde Spray Disinfectants on Dental Impressions. Clin Cosmet Investig Dent. 2020;12:25
  18. Gupta R, Agarwal R, Tiwari S, Bharat A. Comparison of various methods of disinfecting irreversible hydrocolloid impressions using chlorhexidine gluconate: Assessment of antimicrobial efficacy & dimensional changes. J Int Med Dent. 2016;3(3):151–60
  19. Rueggeberg FA, Beall FE, Kelly MT, Schuster GS. Sodium hypochlorite disinfection of irreversible hydrocolloid impression material. J Prosthet Dent. 1992;67(5):628–31
  20. Ghasemi E, Fathi AH, Parvizinia S. Effect of Three Disinfectants on Dimensional Changes of Different Impression Materials. J Islam Dent Assoc Iran. 2019;31(3):169–76
  21. Farzin M, Panahandeh H. Effect of pouring time and storage temperature on dimensional stability of casts made from irreversible hydrocolloid. J Dent. 2010;7(4):179–84
  22. Andari Wulan K, Fitriani Fitriani D, Al Hazmy L. Perbedaan Stabilitas Dimensi Antara Hasil Pencetakan Polieter yang Diperoleh Melalui Teknik Pencampuran Manual dan Pencampuran Otomatis. E-Prodenta J Dent. 2019;3(1):196–207
  23. Badrian H, Ghasemi E, Khalighinejad N, Hosseini N. The effect of three different disinfection materials on alginate impression by spray method. ISRN Dent. 2012;2012:695151
  24. Anusavice KJ, Shen C, Rawls HR. Phillips’ Science of Dental Materials. 12th ed. London: Elsevier Health Sciences; 2012. 151–193 p
  25. Octarina, Raharja J. The effect of seal bag storage on dimensional stability of alginate impression material. Sci Dent J. 2018;2(3):93
  26. Sumantri D, Maulida C. Inhibition effect of hydrocolloid irreversible alginate on soaking spray using aloe vera juice. Intisari Sains Medis. 2018 Sep 14;9(3)
  27. Hamedi Rad F, Ghaffari T, Safavi SH. In vitro evaluation of dimensional stability of alginate impressions after disinfection by spray and immersion methods. J Dent Res Dent Clin Dent Prospects. 2010;4(4):130–5
  28. Martin N, Martin MV, Jedynakiewicz NM. The dimensional stability of dental impression materials following immersion in disinfecting solutions. Dent Mater. 2007 Jun;23(6):760–8
  29. Muzaffar D, Braden M, Parker S, Patel MP. The effect of disinfecting solutions on the dimensional stability of dental alginate impression materials. Dent Mater. 2012;28(7):749–55
  30. Saito S, Ichimaru T, Araki Y. Factors Affecting Dimensional Instability of Alginate Impressions during Immersion in the Fixing and Disinfectant Solutions. Dent Mater J. 1998;17(4):294–300
  31. Hiraguchi H, Kaketani M, Hirose H, Yoneyama T. Effect of immersion disinfection of alginate impressions in sodium hypochlorite solution on the dimensional changes of stone models. Dent Mater J. 2012;31(2):280–6

Last update:

No citation recorded.

Last update:

No citation recorded.