skip to main content

A Comparative Study of Flat Slab and Waffle Slab Structure for Efficiency of Convention Building Slab System

Efendi Efendi  -  Faculty of Civil Engineering & Planning, Batam International University, Indonesia, Indonesia
Andri Irfan Rifai  -  Faculty of Civil Engineering & Planning, Batam International University, Indonesia
*Amanatullah Savitri  -  Faculty of Civil Engineering & Planning, Batam International University, Indonesia

Citation Format:
Abstract

In the world of construction, aesthetic has become an important factor that must be considered. The aesthetic elements consist of wholeness, prominence and balance. However, aesthetic values can be influenced by several factors, namely economic, social, cultural, technological, ergonomic and psychological factors and this cause that in commercial development or the building that use slab system for foundation is used greatly affects it in terms of aesthetics and also cost effectiveness. The author's purpose of doing this research is to analyse the efficiency of volume in concrete and deflection between Flat Slab system and Waffle slab system. This research uses a case study at the Pasir Putih Convention, Batam, Indonesia. The analysis is done with ETABS software based on the local standards or known as Indonesia National Standard (abbreviated SNI). The choice of a slab system in a development is very important, especially if the building or construction is categorized as commercial structure. Based on the data obtained by researchers in terms of economics and deflection, Waffle Slab System is the right choice, meanwhile in terms of ease construction Waffle Slab System will be the secondary choice than Flat Slab, Since Flat Slab is more ease of framework installation than Waffle Slab.

Fulltext View|Download

Article Metrics:

  1. Afshari, H., Hare, W., & Tesfamariam, S. (2019). Constrained multi-objective optimization algorithms: Review and comparison with application in reinforced concrete structures. Applied Soft Computing, 83
  2. Al-Bayati, A. F., Leong, L. T., & Clark, L. A. (2018). Eccentric Punching Shear of Waffle Slab. ACI Structural Journal, 115
  3. Diana, W. (2011). Metode Beam on Elastic Foundation (BoEF) dan Finite Element Method (FEM). Semesta Teknika, 14(1), 94-100
  4. Giri, M., & Jamle, S. (2019). An Approach to Lessen the Stresses in Flat Slab for Earthquake Zone IV. International Journal of Advanced Engineering Research and Science ISSN: 2349-6495 (P), 2456-1908 (O)), 6(6),., 216-224
  5. Johnson, R. P. (2018). Composite Structures of Steel and Concrete: beams, slabs, columns and frames for building. John Wiley & Sons Ltd
  6. Lapi, M., Ramos, A. P., & Orlando, M. (2019). Flat slab strengthening techniques against punching-shear. Engineering Structures, 160-180
  7. Lee, T. U. (2022). Optimizing load locations and directions in structural design. Finite Elements in Analysis and Design, 209
  8. Lionardo, L., & Sari, Y. A. (2022). DESIGN COMPARISON OF STRUCTURAL ELEMENTS BETWEEN CONVENTIONAL SLAB AND RIBBED SLAB ON OPTIMIZATION CONCRETE VOLUME EFFECIENCY. CoMBInES
  9. Malviya, S., & Tiwari, M. V. (2021). Comparative Study of Seismic Behaviour of Multi-Storey Buildings with Flat Slab, Waffle Slab, Ribbed Slab &Slab with Secondary Beam. Journal of Xi'an University of Architecture & Technology, 14
  10. Malviya, S., & Tiwari, M. V. (2021). Comparative Study of Seismic Behaviour of Multi-Storey Buildings with Flat Slab, Waffle Slab, Ribbed Slab &Slab with Secondary Beam. Journal of Xi an University of Architecture & Technology, 14
  11. Nuh, S. M. (2018). Analysis of the Influence of Project Implementation Methods for Time and Cost Efficiency of High-rise Building Work in Pontianak City. JeLAST: Jurnal PWK, Laut, Sipil, Tambang,, 5(3)
  12. Olawale, S. O., Akintunde, O. P., Afolabi, M. O., & Tijani, M. A. (2020). Design Optimization of Reinforced Concrete Waffle Slab Using Genetic Algorithm. Journal of Soft Computing in Civil Engineering, 4(2), 46-62
  13. Pethe, M. D., & Khedikar. (2022). A Comparative Study of Conventional Slab, Flat Slab and Waffle Slab by using Finite Element Method. International Journal for Research in Applied Science & Engineering Technology (IJRASET), 14
  14. Primakov, A., & Leo, E. (2019). Efficiency Study of Flat Slab Systems Using Post-Tension and Conventional Methods. JMTS: Jurnal Mitra Teknik Sipil, 2(1), 133-142
  15. Rupidara, Y. A., Cornelis, R., & Sir, T. M. (2022). Comparative Analysis of Seismic Performance of Building Structures with Conventional Plates, Waffle Slab, dan Flat Slab. Jurnal Forum Teknik Sipil (J-ForTekS) Vol. 2 (1), 80-91
  16. Sacramento, P., Picanco, M., & Oliveira, D. (2018). Reinforced concrete ribbed slabs with wide-beam. Lajes nervuradas de concreto armado com viga-faixa
  17. Shirin, K. P., & George, B. M. (2022). Comparative Analysis and Seismic Performance Improvement of RCC Post Tensioned Flat Slab with Steel Composite PT Flat Slab System using ETABS. International Journal Of Engineering Research & Technology (IJERT) ICART (Volume 10 – Issue 06), 190-196
  18. Sitole, A., Guha, S., & Shekhawat, S. S. (2018). Conversion of MDOF System Into SDOF System of RC Waffle Slab Structure by Using N2 Method. International Research Journal of Engineering and Technology (IRJET), 5
  19. Taha, B. O. (2020). Aspect Ratio Consideration in Flat Plate Concrete Slab Deflection. Zanco Journal of Pure and Applied Sciences, 62-77. Utomo, T. P. (2010)
  20. Youlanda, N. A., & Winaya, A. (2016). Comparative study of two-way ribbed slab (waffle slab) and conventional slab. Jurnal Iptek, 20(1), 25-36

Last update:

No citation recorded.

Last update:

No citation recorded.