The Effect of Plasma Nitridation on Surface Hardness of Titanium Alloy (Ti-6Al-4V) for Artificial Knee Joint Applications

Angga Yunis Prasetya; Darmanto Darmanto; Muhammad Dzulfikar

doi:10.14710/jbiomes.2021.v1i2.49-53

DOI: https://doi.org/10.14710/jbiomes.2021.v1i2.49-53

The Effect of Plasma Nitridation on Surface Hardness of Titanium Alloy (Ti-6Al-4V) for Artificial Knee Joint Applications

Angga Yunis Prasetya - Department of Mechanical Engineering, Faculty of Engineering, Universitas Wahid Hasyim, Indonesia

*Darmanto Darmanto

- Department of Mechanical Engineering, Faculty of Engineering, Universitas Wahid Hasyim, Indonesia

Muhammad Dzulfikar - Department of Mechanical Engineering, Faculty of Engineering, Universitas Wahid Hasyim, Indonesia

Citation Format:

Abstract

Nitriding has been carried out using plasma nitriding techniques for surface treatment of Titanium as a biomaterial component. The purpose of this study was to determine the effect of plasma nitriding on surface hardness that occurs in titanium. The material used is Titanium Alloy (Ti-6Al-4V) Grade 5 which is processed by plasma nitriding by varying nitrogen (N₂) and argon (Ar) gases of (100% N₂/0% Ar), (95% N₂/5% Ar), (90% N₂/10% Ar), (85% N₂/15% Ar), (80% N₂/20% Ar), and (75% N₂/25% Ar), and temperature 400ºC, time 5 hours and a pressure of 1.6 bar. The test results show that the optimum hardness is found in the gas composition with a ratio of 95% N₂: 5% Ar. Obtained a hardness of 371 HV/VHN or an increase of 159% of the raw material with hardness value of 143 HV/VHN

Fulltext View|Download

Keywords: Titanium Alloy, Plasma Nitridation, Hardness, gas, nitrogen, argon

Article Metrics:

Article Info

Section: Articles

Language : EN

In Vol 1, No 2 (2021)

Recent articles

MoFlus: An Open-Source Android Software for Fluorescence-Based Point of Care A Review of Existing Transtibial Bionic Prosthesis: Mechanical Design, Actuators and Power Transmission The Effect of Plasma Nitridation on Surface Hardness of Titanium Alloy (Ti-6Al-4V) for Artificial Knee Joint Applications More recent articles

Last update:

No citation recorded.

Last update:

No citation recorded.

The Authors submitting a manuscript do so on the understanding that if accepted for publication, copyright of the article shall be assigned to Journal of Biomedical Science and Bioengineering and Diponegoro University as publisher of the journal.

Copyright encompasses exclusive rights to reproduce and deliver the article in all form and media, including reprints, photographs, microfilms and any other similar reproductions, as well as translations. The reproduction of any part of this journal, its storage in databases and its transmission by any form or media, such as electronic, electrostatic and mechanical copies, photocopies, recordings, magnetic media, etc. , will be allowed only with a written permission from Journal of Biomedical Science and Bioengineering and Diponegoro University.

Journal of Biomedical Science and Bioengineering and Center of Biomass and Diponegoro University, the Editors and the Advisory International Editorial Board make every effort to ensure that no wrong or misleading data, opinions or statements be published in the journal. In any way, the contents of the articles and advertisements published in the Journal of Biomedical Science and Bioengineering are sole and exclusive responsibility of their respective authors and advertisers.